How to Set Up an Agent with PoE

FastE and WiFi Agents

  1. Insert the micro-USB output of the PoE splitter into the micro-USB input of the Agent
  2. Insert the Ethernet cable of the splitter into the interface of the Agent
  3. Connect the Ethernet cable from your switch to the "DATA IN" port of the PoE
  4. You should see the red LED on the Agent turn on

 

20190212_135216.jpg

 

GigE Agents PoE Type 1

  1. Connect the Ethernet cable from your switch (blue cable) to the "IN" port of the PoE
  2. Wait for the Green LED on the PoE to turn on
  3. Use the short Ethernet cable to connect the Agent's interface to the "OUT" port of the PoE
  4. Insert the barrel jack power cable to the power input of the GigE Agent
  5. The blue LED on the agent should turn on

20191031_153355.jpg

GigE Agents PoE Type 2

  1. Check the PoE's Voltage switch and make sure it is set tp 5V (move switch all the way to the end, closer to the side with the POWER and DATA OUT ports)
  2. Insert the straight end of the barrel cable to the "Power" output of the PoE
  3. Insert the other end of the barrel cable to the power input of the GigE Agent
  4. Use the short Ethernet cable to connect the Agent's interface to the "DATA OUT" port of the PoE
  5. Connect the Ethernet cable from your switch to the "DATA IN" port of the PoE
  6. The green LED corresponding to 5V should turn on and then the blue LED on the agent should turn on

20190212_133733.jpg

Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.