How to setup an agent with PoE

FastE and WiFi agents

  1. Insert the micro-USB output of the PoE splitter into the micro-USB input of the agent
  2. Insert the Ethernet cable of the splitter into the interface of the agent
  3. Connect the Ethernet cable from your switch to the "DATA IN" port of the PoE
  4. You should see the red LED on the agent turn on

 

20190212_135216.jpg

 

GigE agents

  1. Check the PoE's Voltage switch and make sure it's on 5V (move switch all the way to the end, closer to the side with the POWER and DATA OUT ports).
  2. Insert the straight end of the barrel cable to the "Power" output of the PoE
  3. Insert the other end of the barrel cable to the power input of the GigE agent
  4. Use the short Ethernet cable to connect the agent's interface to the "DATA OUT" port of the PoE
  5. Connect the Ethernet cable from your switch to the "DATA IN" port of the PoE
  6. The Green LED corresponding to 5 V should and the LED on the agent turn on

20190212_133733.jpg

Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.